Workshop manual

Seat Belts

Inspection

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF page 2058 (manual page 24-6)

PDF p. 2058 · 24-6

SRS components are located in this area. Review the SRS component locations, precautions and procedures in the 1999 HR-V Shop Manual, P/N. 62S2H00, before performing repairs or service.

Retractor:

  1. 1.
    Before installing the retractor, check that the seat belt can be pulled out freely.
  2. 2.
    Make sure that the seat belt does not lock when the retractor is leaned slowly up to 15° from the mounted position. The seat belt should lock when the retractor is leaned over 40°. Do not attempt to disassemble the retractor.

Front (5D): *: Mounted Position

Illustration: Inside; RETRACTOR; Forward
  1. 1. Inside
  2. 2. RETRACTOR
  3. 3. Forward

Rear (5D):

Illustration: Forward; RETRACTOR; Inside
  1. 1. Forward
  2. 2. RETRACTOR
  3. 3. Inside
  1. 3.
    Replace the seat belt with a new assembly if there is any abnormality. Do not disassemble any part of the seat belt for any reason.

In-vehicle:

  1. 1.
    Check that the seat belt is not twisted or caught on anything.
  2. 2.
    After installing the anchors, check for free movement on the anchor bolts. If necessary, remove the anchor bolts and check that the washers and other parts are not damaged or improperly installed.
  3. 3.

    Check the seat belts for damage or discolouration. Clean with a shop towel if necessary. Use only soap and water to clean.

    NOTE: Dirt build-up in the metal loops of the upper anchors can cause the seat belts to retract slowly. Wipe the inside of the loops with a clean cloth dampened in isopropyl alcohol.

  4. 4.
    Check that the seat belt does not lock when pulled out slowly. The seat belt is designed to lock only during a sudden impact.
  5. 5.
    Make sure that the seat belt will retract automatically when released.
  6. 6.
    On the rear shoulder seat belt, make sure that the locking mechanism in the seat belt retractor will engage when the seat belt is pulled all the way out.
  7. 7.
    Replace the seat belt with a new assembly if there is any abnormality. Do not disassemble any part of the seat belt for any reason.