Workshop manual

Front Seat Belt

Replacement

Supplement 2000 (5-door model) · source: HRV_Workshop_Manual.pdf, PDF pages 2060, 2061 (manual pages 24-8 to 24-9)

PDF p. 2060 · 24-8

Removal

  1. 1.
    Disconnect the negative battery cable, and wait at least three minutes before beginning work.
  2. 2.
    Remove the centre pillar lower trim panel.
  3. 3.
    Disconnect the seat belt tensioner 2P connector from the SRS main harness 2P connector.
  4. 4.
    Remove the lower anchor bolt.
Illustration: SEAT BELT TENSIONER 2P CONNECTOR; RETRACTOR; SRS MAIN HARNESS 2P CONNECTOR
  1. 1. SEAT BELT TENSIONER 2P CONNECTOR
  2. 2. RETRACTOR
  3. 3. SRS MAIN HARNESS 2P CONNECTOR

5 Remove the upper anchor cover and upper anchor

bolt.

Illustration: UPPER ANCHOR COVER; UPPER ANCHOR BOLT
  1. 1. UPPER ANCHOR COVER
  2. 2. UPPER ANCHOR BOLT

6 Remove the two retractor mounting bolts, then

remove the retractor.

Illustration: MOUNTING BOLT; RETRACTOR; MOUNTING BOLT
  1. 1. MOUNTING BOLT
  2. 2. RETRACTOR
  3. 3. MOUNTING BOLT

PDF p. 2061 · 24-9

Installation

  1. 1.
    Install the new seat belt.
Illustration: SEAT BELT TENSIONER 2P CONNECTOR; MOUNTING BOLT 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft); RETRACTOR; MOUNTING BOLT 32 Nm (3.3 kgf/m, 24 lbf/ft); SRS MAIN HARNESS 2P CONNECTOR
  1. 1. SEAT BELT TENSIONER 2P CONNECTOR
  2. 2. MOUNTING BOLT 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  3. 3. RETRACTOR
  4. 4. MOUNTING BOLT 32 Nm (3.3 kgf/m, 24 lbf/ft)
  5. 5. SRS MAIN HARNESS 2P CONNECTOR
  1. 2.
    Reinstall the upper anchor bolt and upper anchor cover.
Illustration: UPPER ANCHOR COVER; UPPER ANCHOR BOLT 32 Nm (3.3 kgf/m, 24 lbf/ft)
  1. 1. UPPER ANCHOR COVER
  2. 2. UPPER ANCHOR BOLT 32 Nm (3.3 kgf/m, 24 lbf/ft)
  1. 3.
    Reinstall the lower anchor bolt.
  2. 4.
    Reconnect the seat belt tensioner 2P connector to SRS main harness 2P connector.
  3. 5.
    Reinstall the centre pillar lower trim panel.
  4. 6.
    Reconnect the negative battery cable.
  5. 7.
    After installing the seat belt, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.