Workshop manual

Seat Belt

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 1333, 1335 (manual pages 24-64 to 24-65)

PDF p. 1333 · 24-64

Review the front seat belt replacement in the Seat Belts section (24) before performing repair or service.

Removal

  1. 1.
    Disconnect the negative battery cable and wait at least three minutes before beginning work.
  2. 2.
    Remove the rear set then remove the centre pillar trim (see section 20).
  3. 3.
    Disconnect the seatbelt tensioner 2P connector from the SRS main harness 2P connector.
Illustration: SEAT BELT TENSIONER 2P CONNECTOR; RETRACTOR; SRS MAIN HARNESS 2P CONNECTOR
  1. 1. SEAT BELT TENSIONER 2P CONNECTOR
  2. 2. RETRACTOR
  3. 3. SRS MAIN HARNESS 2P CONNECTOR
  1. 4.
    Remove the upper anchor cover and upper anchor bolt.
Illustration: UPPER ANCHOR COVER; UPPER ANCHOR BOLT
  1. 1. UPPER ANCHOR COVER
  2. 2. UPPER ANCHOR BOLT
  1. 5.
    Remove the two retractor mounting bolts, then remove the retractor.
Illustration: MOUNTING BOLT; RETRACTOR; MOUNTING BOLT
  1. 1. MOUNTING BOLT
  2. 2. RETRACTOR
  3. 3. MOUNTING BOLT

PDF p. 1335 · 24-65

Installation

  1. 1.
    Install the new seat belt.
Illustration: SEAT BELT TENSIONER 2P CONNECTOR; MOUNTING BOLT 9.8 Nm (1.0 kgf/m, 7.2lbf/ft); RETRACTOR; MOUNTING BOLT 32 Nm (3.3 kgf/m, 24lbf/ft); SRS MAIN HARNESS 2P CONNECTOR
  1. 1. SEAT BELT TENSIONER 2P CONNECTOR
  2. 2. MOUNTING BOLT 9.8 Nm (1.0 kgf/m, 7.2lbf/ft)
  3. 3. RETRACTOR
  4. 4. MOUNTING BOLT 32 Nm (3.3 kgf/m, 24lbf/ft)
  5. 5. SRS MAIN HARNESS 2P CONNECTOR
  1. 2.
    Reinstall the upper anchor bolt and upper anchor cover.
Illustration: UPPER ANCHOR COVER; UPPER ANCHOR BOLT, 32 Nm (3.3 kgf/m, 24 lbf/ft)
  1. 1. UPPER ANCHOR COVER
  2. 2. UPPER ANCHOR BOLT, 32 Nm (3.3 kgf/m, 24 lbf/ft)
  1. 3.
    Reconnect the seat belt tensioner 2P connector to SRS main harness 2P connector.
  2. 4.
    Reinstall the centre pillar trim and the rear seat (see section20).
  3. 5.
    Reconnect the negative battery cable.
  4. 6.
    After installing the seat belt, confirm proper system operation. Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.