Workshop manual

Front Passenger’s Airbag

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 1331, 1332 (manual pages 24-62 to 24-63)

PDF p. 1331 · 24-62

Removal

  1. 1.
    Disconnect the negative battery cable, and wait at least three minutes before beginning work.
  2. 2.
    Remove the glove box (see section 20), then disconnect the connector between the SRS main harness 2P connector and front passenger’s airbag 2P connector.
Illustration: SRS MAIN HARNESS 2P CONNECTOR; FRONT PASSENGER’S AIRBAG 2P CONNECTOR
  1. 1. SRS MAIN HARNESS 2P CONNECTOR
  2. 2. FRONT PASSENGER’S AIRBAG 2P CONNECTOR
  1. 3.

    Remove the three mounting nuts from the bracket. Cover the lid and dashboard with a cloth, and pry carefully with a screwdriver to lift the front passenger’s airbag out of the dashboard.

    NOTE: The airbag lid has pawls on the side which is attached to the dashboard.

Illustration: FRONT PASSENGER’S AIRBAG; FRONT PASSENGER’S AIRBAG MOUNTING NUTS
  1. 1. FRONT PASSENGER’S AIRBAG
  2. 2. FRONT PASSENGER’S AIRBAG MOUNTING NUTS

PDF p. 1332 · 24-63

Installation

  1. 1.
    Place the new front passenger’s airbag into the dashboard. tighten the front passenger’s airbag mounting nuts.
Illustration: FRONT PASSENGER’S AIRBAG; FRONT PASSENGER’S AIRBAG MOUNTING NUTS, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  1. 1. FRONT PASSENGER’S AIRBAG
  2. 2. FRONT PASSENGER’S AIRBAG MOUNTING NUTS, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  1. 2.
    Connect the front passenger’s airbag 2P connector to the SRS main harness 2P connector. Attach the front passenger’s airbag connector to the connector holder, then reinstall the glove box.
Illustration: CONNECTOR HOLDER; SRS MAIN HARNESS 2P CONNECTOR; FRONT PASSENGER’S AIRBAG 2P CONNECTOR
  1. 1. CONNECTOR HOLDER
  2. 2. SRS MAIN HARNESS 2P CONNECTOR
  3. 3. FRONT PASSENGER’S AIRBAG 2P CONNECTOR
  1. 3.
    Reconnect the negative battery cable.
  2. 4.
    After installing the airbag, confirm proper system operation. Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.