Workshop manual

Driver’s Airbag

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 1329, 1330 (manual pages 24-60 to 24-61)

PDF p. 1329 · 24-60

Removal

  1. 1.
    Disconnect the negative battery cable and wait at least three minutes before beginning work.
  2. 2.
    Remove the access panel from the steering wheel, then disconnect the connector between the cable reel 2P connector and driver’s airbag 2P connector. Then disconnect the horn connector.
Illustration: HORN CONNECTOR; CABLE REEL 2P CONNECTOR; ACCESS PANEL; DRIVER’S AIRBAG 2P CONNECTOR
  1. 1. HORN CONNECTOR
  2. 2. CABLE REEL 2P CONNECTOR
  3. 3. ACCESS PANEL
  4. 4. DRIVER’S AIRBAG 2P CONNECTOR
  1. 3.
    Remove the covers from the steering wheel, then remove the two Torx bolts using a Torx T30 bit. The remove the driver’s airbag.
Illustration: DRIVER’S AIRBAG; TORX BOLTS Use a Torx T30 bit
  1. 1. DRIVER’S AIRBAG
  2. 2. TORX BOLTS
    Use a Torx T30 bit

PDF p. 1330 · 24-61

Installation

  1. 1.
    Place the new driver’s airbag in the steering wheel and secure it with new Torx bolts.
Illustration: TORX BOLTS, 9.8 Nm (10. kgf/m, 7.2 lbf/ft) Replace; DRIVER’S AIRBAG
  1. 1. TORX BOLTS, 9.8 Nm (10. kgf/m, 7.2 lbf/ft) Replace
  2. 2. DRIVER’S AIRBAG
  1. 2.
    Connect the cable reel 2P connector to the driver’s airbag 2P connector, and horn connector, then install the access panel on the steering wheel.
Illustration: HORN CONNECTOR; CABLE REEL 2P CONNECTOR; ACCESS PANEL; DRIVER’S AIRBAG 2P CONNECTOR
  1. 1. HORN CONNECTOR
  2. 2. CABLE REEL 2P CONNECTOR
  3. 3. ACCESS PANEL
  4. 4. DRIVER’S AIRBAG 2P CONNECTOR
  1. 3.
    Connect the negative battery cable.
  2. 4.
    After installing the airbag, confirm proper system operation:
    • Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.
    • Make sure the horn button works.