Workshop manual

Precautions/Procedures

Wiring Precautions

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1283 (manual page 24-20)

PDF p. 1283 · 24-20

  • SRS wiring can be identified by special yellow outer covering (except the SRS indicator light circuit). Observe the instructions described in this section.
  • Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring, replace the harness.
Illustration · Precautions/Procedures · Wiring Precautions
  • Be sure to install the harness wires so that they are not pinched, or interfere with other parts.
Illustration · Precautions/Procedures · Wiring Precautions
  • Make sure all SRS ground locations are clean and grounds are securely fastened for optimum metal-to-metal contact. Poor grounding can cause intermittent problems that are difficult to diagnose.

Precautions for Electrical Inspections

  • When using electrical test equipment, insert the probe of the tester into the wire side of the connector. Do not insert the probe of the tester into the terminal side of the connector and do not tamper with the connector. Inserting the probe into the terminal side of the connector, and tampering with the connector could cause malfunction of the SRS system or an error in inspection.
Illustration · Precautions for Electrical Inspections
  • Use a U-shaped probe. Do not insert the probe forcibly.
Illustration · Precautions for Electrical Inspections
  • Use specified service connectors in troubleshooting. Using tools which are not specified standard design could cause an error in inspection due to poor metal-to-metal contact.