Workshop manual

Precautions/Procedures

SRS Unit Precautions

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1282 (manual page 24-19)

PDF p. 1282 · 24-19

  • Be careful not to bump or impact the SRS unit whenever the ignition switch is ON (II), or at least for three minutes after the ignition switch is turned OFF.
  • During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit. The airbags could accidently deploy and cause damage or injury.
Illustration · Precautions/Procedures · SRS Unit Precautions
  • After a collision in which the airbags were deployed, replace the SRS unit. After a collision in which the airbags were not deployed, inspect for any damage or deformation on the SRS unit. If there is any damage, replace the SRS unit.
Illustration · Precautions/Procedures · SRS Unit Precautions
  • Do not disassemble the SRS unit.
  • Turn the ignition switch OFF, disconnect the battery negative cable and wait at least three minutes before beginning installation or replacement of the SRS unit, and disconnection of the 18P connector.
  • Be sure the SRS unit is installed securely to the specified torque.

    TORQUE: 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)

  • Do not spill water or oil on the SRS unit and keep it away from dust.
  • Store the SRS unit in a cool (less than 40°C/104°F) and dry (less than 80% relative humidity, not moisture) area.

Steering-related Precautions

Cable Reel Alignment

  • Centre the cable reel whenever the following is performed (See Page 24-68). Misalignment of the cable reel (the cable reel is not centred) could cause an open in the cable reel, making the SRS system and the horns inoperative.
    • Installation of the steering wheel
    • Installation of the cable reel
    • Installation of the steering column
    • Other steering-related adjustment or installation.
  • Do not disassemble the cable reel.
  • Do not apply grease on the cable reel.
  • If the cable reel shows any signs of damage for example, it does not rotate smoothly, replace the cable reel with a new one.