Workshop manual

Charging System

Rotor Slip Ring Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 221 (manual page 4-37)

PDF p. 221 · 4-37

  1. 1.

    Check the resistance between the slip rings

    There should be 1.8 - 3.0 ohms.

    • If resistance meets the specification, go to step 2.
    • If resistance does not meet the specification, replace the alternator.
Illustration: ROTOR SHAFT; ROTOR; SLIP RINGS
  1. 1. ROTOR SHAFT
  2. 2. ROTOR
  3. 3. SLIP RINGS
  1. 2.
    Check that there is no continuity between the slip rings and the rotor or rotor shaft.
  2. 3.
    If the rotor fails either continuity check, replace the alternator.

Stator Test

  1. 1.

    Check that there is continuity between each pair of leads.

    Nippondenso:

Illustration: LEADS; COIL CORE
  1. 1. LEADS
  2. 2. COIL CORE

Mitsubishi:

Illustration: LEADS; COIL CORE
  1. 1. LEADS
  2. 2. COIL CORE
  1. 2.
    Check that there is no continuity between each lead and the coil core.
  2. 3.
    If the coil fails either continuity check, replace the alternator.