Workshop manual

Charging System

Alternator Brush Inspection (DENSO)

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 220 (manual page 4-36)

PDF p. 220 · 4-36

  1. 1.
    Remove the end cover, then take out the brush holder by removing its two screws.
  2. 2.

    Measure the length of the brushes with a vernier caliper.

    Alternator Brush Length:

    Standard (New): 10.5 mm (0.41 in)

    Service Limit: 1.5 mm (0.06 in)

Illustration: VERNIER CALIPER; ALTERNATOR BRUSHES
  1. 1. VERNIER CALIPER
  2. 2. ALTERNATOR BRUSHES
  1. 3.
    If the brushes are less than the service limit, replace the alternator brush assembly.

Alternator Brush Inspection (MITSUBISHI)

  1. 1.
    Separate the drive-end housing from the rear housing as described on page 4-34.
  2. 2.
    Separate the rear housing from the stator/rectifier assembly by removing the four screws and the terminal nut from the rear housing (See page 4-34).
  3. 3.

    Measure the length of the brushes with a vernier caliper.

    Alternator Brush Length:

    (1) Standard (New): 19 mm (0.75 in)

    1. (2)
      Service Limit: 5 mm (0.20 in)
Illustration · Alternator Brush Inspection (MITSUBISHI)
  1. 4.
    If the brushes are less than the service limit, replace them.
Illustration: SOLDERING IRON
  1. 1. SOLDERING IRON