Workshop manual

Wipers/Washers

Windshield/Rear Window Washer Motor Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1251 (manual page 23-F-32)

PDF p. 1251 · 23-F-32

  1. 1.
    Remove the left front inner fender (see section 20).
  2. 2.
    Disconnect the 2P connector from the washer motor.
Illustration: WINDSHIELD WASHER MOTOR; REAR WINDOW WASHER MOTOR
  1. 1. WINDSHIELD WASHER MOTOR
  2. 2. REAR WINDOW WASHER MOTOR
  1. 3.
    Test the washer motor operation by connecting battery power and ground according to the table.
Illustration · Wipers/Washers · Windshield/Rear Window Washer Motor Test
  • If the motor does not run or fails to run smoothly, replace it.
  • If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged pump outlet in the motor.

Washer Reservoir Replacement

  1. 1.
    Remove the left front inner fender (see section 20).
  2. 2.
    Remove the washer filler.
  3. 3.
    Remove the three mounting bolts from the washer reservoir.
Illustration: WASHER FILLER; WASHER FLUID RESERVOIR; 6 x 1.0 mm 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  1. 1. WASHER FILLER
  2. 2. WASHER FLUID RESERVOIR
  3. 3. 6 x 1.0 mm 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
  1. 4.
    Disconnect the connectors and washer hoses from the washer motors.
Illustration: WASHER FLUID RESERVOIR; CONNECTORS; REAR WASHER HOSE; REAR WINDOW WASHER MOTOR; WINDSHIELD WASHER MOTOR; WINDSHIELD WASHER HOSE
  1. 1. WASHER FLUID RESERVOIR
  2. 2. CONNECTORS
  3. 3. REAR WASHER HOSE
  4. 4. REAR WINDOW WASHER MOTOR
  5. 5. WINDSHIELD WASHER MOTOR
  6. 6. WINDSHIELD WASHER HOSE

NOTE:

  • Make sure the connectors and washer hoses are connected properly.
  • Check the washer motor operation.