Workshop manual

Wipers/Washers

Rear Window Wiper Motor Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1250 (manual page 23-F-31)

PDF p. 1250 · 23-F-31

  1. 1.
    Remove the tailgate trim panel (see section 20).
  2. 2.
    Disconnect the 4P connector from the wiper motor assembly.
Illustration: Terminal side of male terminals; 4P CONNECTOR; REAR WIPER MOTOR
  1. 1. Terminal side of male terminals
  2. 2. 4P CONNECTOR
  3. 3. REAR WIPER MOTOR
  1. 3.

    Test the motor by connecting battery power to the No. 1 terminal and ground to the No. 3 terminal.

    If the motor does not run or fails to run smoothly, replace it.

  2. 4.
    Reconnect the 4P connector to the wiper motor.
  3. 5.
    Connect an analogue voltmeter between the No. 4 (+) and No. 2 (-) terminals.
  4. 6.

    Run the motor by turning the wiper switch ON.

    The voltmeter should indicate 0V and 4V or less alternately.

Rear Window Wiper Motor Replacement

  1. 1.
    Remove the tailgate trim panel (see section 20).
  2. 2.
    Remove the rear window wiper arm.
Illustration: REAR WINDOW WIPER ARM; COVER; 6 x 1.0 mm, 14 Nm (1.4 kgf/m, 10 lbf/ft)
  1. 1. REAR WINDOW WIPER ARM
  2. 2. COVER
  3. 3. 6 x 1.0 mm, 14 Nm (1.4 kgf/m, 10 lbf/ft)
  1. 3.
    Disconnect the 4P connector from the motor.
  2. 4.
    Remove the three mounting bolts from the tailgate.
Illustration: REAR WIPER MOTOR; 4P CONNECTOR; 6 x 1.0 mm, 8 Nm (0.8 kgf/m, 6 lbf/ft)
  1. 1. REAR WIPER MOTOR
  2. 2. 4P CONNECTOR
  3. 3. 6 x 1.0 mm, 8 Nm (0.8 kgf/m, 6 lbf/ft)