Workshop manual

Power Windows

Driver’s Window Motor Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1206 (manual page 23-E-12)

PDF p. 1206 · 23-E-12

Motor Test:

  1. 1.
    Remove the driver’s door panel and disconnect all connectors (see section 20).
  2. 2.
    Disconnect the 6P connector from the window motor.
Illustration: Terminal side of male terminals; 6P CONNECTOR
  1. 1. Terminal side of male terminals
  2. 2. 6P CONNECTOR
  1. 3.
    Test the motor in each direction by connecting battery power and ground according to the table.
Illustration · Motor Test
  1. 4.
    If the motor does not run or fails to run smoothly, replace it.

Detect Circuit Test:

  1. 1.
    Reconnect the 6P connector to the window motor.
  2. 2.
    Check for voltage between the terminals:
    • There should be battery voltage between No. 6 (+) and No. 4 (-) terminals when the ignition switch is ON (II).
    • Connect the analogue voltmeter between the No. 5 (+) and No. 4 (-) terminals and run the window motor down or up.

      The voltmeter needle should move back and forth alternately.

    • Connect the analogue voltmeter between the No. 3 (+) and No. 4 (-) terminals and run the window motor down or up.

      The voltmeter needle should move back and forth alternately.