Workshop manual

Turn Signal/Hazard Flasher System

Hazard Warning Switch Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1189 (manual page 23-D-23)

PDF p. 1189 · 23-D-23

  1. 1.
    Remove the centre panel from the dashboard (see section 20).
  2. 2.
    Disconnect the 10P connector from the switch.
  3. 3.
    Push the switch out from behind the centre panel.
Illustration: HAZARD WARNING SWITCH; BULB (0.84W); 10P CONNECTOR
  1. 1. HAZARD WARNING SWITCH
  2. 2. BULB (0.84W)
  3. 3. 10P CONNECTOR
  1. 4.
    Check for continuity between the terminals in each switch position according to the table.
Illustration · Turn Signal/Hazard Flasher System · Hazard Warning Switch Test