Workshop manual

Turn Signal/Hazard Flasher System

Turn Signal/Hazard Relay Input Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1188 (manual page 23-D-22)

PDF p. 1188 · 23-D-22

  1. 1.
    Remove the turn signal/hazard relay from the under-dash fuse/relay box.
  2. 2.
    Inspect the relay and fuse/relay box socket terminals to make sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
    • If the terminals look OK, make the following input tests at the fuse/relay box socket.
      • If any test indicates a problem, find and correct the cause, then recheck the system.
      • If all the input tests prove OK, the turn signal/hazard relay must be faulty, replace it.
Illustration: TURN SIGNAL/HAZARD RELAY; UNDER-DASH FUSE/RELAY BOX
  1. 1. TURN SIGNAL/HAZARD RELAY
  2. 2. UNDER-DASH FUSE/RELAY BOX
CavityTest conditionTest: Desired resultPossible cause if result is not
obtained
2Under all conditionsCheck for continuity to ground:♦Poor ground (G401, G402)
There should be continuity♦An open in the wire
3Ignition switch ON (II)Check for voltage to ground:♦Blown No 5 (10A) fuse in the
There should be battery voltageunder-dash fuse/relay box.
♦An open in the wire
♦Faulty hazard warning switch
Hazard warning switch ONCheck for voltage to ground:♦Blown No 49 (*A) fuse in the
There should be battery voltageunder-hood fuse/relay box
♦An open in the wire
♦Faulty hazard warning switch
1Hazard warning switch ON;Hazard lights should come on♦Poor ground (G201, G301, G401,
connect the No 2 terminal toG402, G501)
the No 3 terminal.♦Faulty hazard warning switch
♦An open in the wire
Ignition switch ON (II) andRight or left turn signal lights♦Faulty turn signal switch
turn signal switch in Right orshould come on
Left; connect the No 2
terminal to the No 3 terminal

*15A: KG, KE models

10A: Except KG,KE models