PDF p. 1087 · 22-32
- 1.Remove the centre nut while holding the armature plate with the special tool.

- 1. A/C CLUTCH HOLDER, 07NAB-HAC0100
- 2. CENTRE NUT, 17.6 Nm (1.8 kgf/m, 13 lbf/ft), Replace
- 3. ARMATURE PLATE
- 2.Remove the armature plate by pulling it up by hand.

- 1. ARMATURE PLATE
- 2. SHIM(S), Replace
- 3.Remove the snap ring B with snap ring pliers. Be careful not to damage the rotor pulley and compressor.

- 1. SNAP RING B, Replace
- 2. ROTOR PULLEY
- 4.Remove the rotor pulley from the shaft with the tools. Be sure the claws of the puller are on the back of the rotor pulley, not on the belt area; otherwise the rotor pulley can be damaged.

- 1. DRIVER ATTACHMENT, 07947-6340300
- 2. PULLER (Commercially available)
- 3. ROTOR PULLEY
PDF p. 1088 · 22-33
- 5.Remove the bolt, holder, screw and clamp, then disconnect the field coil connector. Remove the snap ring A with snap ring pliers, then remove the field coil. Be careful not to damage the field coil and compressor.

- 1. SNAP RING A, Replace
- 2. FIELD COIL
- 3. CLAMP
- 4. HOLDER
- 5. GROUND TERMINAL
- 6. 7.4 Nm (0.75 kgf/m, 5 lbf/ft)
- 7. Align
- 6.
Position the rotor pulley squarely over the field coil. Press the rotor pulley onto the compressor boss with the special tool. If the rotor pulley does not press on straight, remove it and check the rotor pulley and compressor boss for burrs or damage.
Maximum press load: 32,200 kPa (400 kgf/cm2, 5,690 psi)

- 1. ROTOR PULLEY
- 2. Press
- 3. HUB ASSEMBLY GUIDE ATTACHMENT, 07965-6920500
- 7.Reassemble the compressor clutch in the reverse order of disassembly and note the following items.
- Install the filed coil with the wire side facing down and align the boss on the field coil with the hole in the compressor.
- Clean the rotor pulley and compressor sliding surfaces with non-petroleum solvent.
- Install new snap rings and make sure they are fully seated in the groove.
- Make sure that the rotor pulley turns smoothly after its reassembled.
- Route and clamp the wires properly or they can be damaged by the rotor pulley.