Workshop manual

Heater Core

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1053 (manual page 21-18)

PDF p. 1053 · 21-18

NOTE:

  • LHD type is shown, RHD type is symmetrical.
  • The heater core can be replaced without removing the blower motor and the blower resistor.
  1. 1.
    Remove the heater unit (see previous page).
  2. 2.
    Remove the self-tapping screws, then carefully separate the housing B from the housing A. Be careful no to bend the inlet and outlet pipes, and remove the heater core.
  1. 3.
    Reassemble in the reverse order of disassembly and note these items:
    • Make sure that there are is no air leakage.
    • After reassembly, make sure that the mode control linkage and doors and the air mix control linkage and the door moves smoothly.
Illustration: HOUSING B; HOUSING A; BLOWER MOTOR Test, (See Page 21-7); BLOWER RESISTOR Test, (See Page 21-6); HEATER CORE
  1. 1. HOUSING B
  2. 2. HOUSING A
  3. 3. BLOWER MOTOR Test, (See Page 21-7)
  4. 4. BLOWER RESISTOR Test, (See Page 21-6)
  5. 5. HEATER CORE