PDF p. 1051 · 21-16
SRS components are located in this area. review the SRS component locations, precautions and procedures in the SRS section (24) before performing repairs or service.
NOTE: LHD type is shown, RHD type is symmetrical.
- 1.Disconnect the negative cable from the battery.
- 2.From under the hood, open the cable clamp, then disconnect the heater valve cable from the heater valve arm. Turn the heater valve arm to the fully opened positioned as shown.

- 1. CLAMP
- 2. HEATER VALVE CABLE
- 3. HEATER VALVE ARM
- 3.When the engine is cool, drain the engine coolant from the radiator (see section 10).
- 4.Slide the clamps back, then disconnect the inlet and outlet heater hoses from the heater unit. Engine coolant will run out when the hoses are disconnected; drain it into a clean drip pan. Be sure not to let coolant spill on the electrical parts or the painted surfaces. If any coolant spills, rinse it off immediately.

- 1. HEATER HOSE (INLET SIDE)
- 2. HEATER HOSE (OUTLET SIDE)
- 3. CLAMPS
- 5.Remove the mounting nut from the heater unit. Take care not to damage or bend the fuel and brake lines, etc.

- 1. 8 x 1.25 mm, 22 Nm (22. kgf/m, 16 lbf/ft)
PDF p. 1052 · 21-17
- 6.Remove the dashboard (see section 20).
- 7.Remove the mounting bolts in the following sequence, then remove the steering hanger beam.

- 1. STEERING HANGER BEAM
- 2. 8 x 1.25 mm, 22 Nm (2.2 kgf/m, 16 lbf/ft)
- 3. 8 x 1.25 mm, 22 Nm (2.2 kgf/m, 16 lbf/ft)
- 4. STEERING HANGER BEAM
- 8.With air conditioning; remove the evaporator (See Page 22-26).
- 9.Without air conditioning; disconnect the connector from the recirculation control motor, then remove the clip, the wire harness clip, the self-tapping screws, the mounting bolts, the mounting nut and the heater duct.

- 1. HEATER DUCT
- 2. 6 x 1.0 mm, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
- 3. CLIP
- 4. CONNECTOR
- 5. CLIP
- 6. 6 x 1.0 mm, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
- 10.Disconnect the connectors from the blower motor and the blower resistor, then remove the wire harness clips, the mounting nuts and the heater unit.

- 1. 6 x 1.0 mm, 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
- 2. HEATER UNIT
- 3. CONNECTORS
- 4. CLIPS
- 11.Install in the reverse order of removal and note these items:
- Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
- Refill the cooling system with engine coolant (see section 10).
- Adjust the mode control cable (See Page 21-19), and adjust the air mix control cable and the heater valve cable (See Page 21-20).
- Make sure that there are is no air leakage.