Workshop manual

Heater Control Panel

Overhaul

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1050 (manual page 21-15)

PDF p. 1050 · 21-15

Illustration: AIR MIX CONTROL CABLE; MODE CONTROL CABLE; HEATER FAN SWITCH Test, (See Page 21-11)
  1. 1. AIR MIX CONTROL CABLE
  2. 2. MODE CONTROL CABLE
  3. 3. HEATER FAN SWITCH Test, (See Page 21-11)

Control Cable Replacement

  1. 1.
    Cut the inner cable on the slider side of the cable holder, then remove both pieces of the inner cable.
Illustration: SLIDER; CUT; STOPS; CABLE HOUSING; CONTROL CABLE
  1. 1. SLIDER
  2. 2. CUT
  3. 3. STOPS
  4. 4. CABLE HOUSING
  5. 5. CONTROL CABLE
  1. 2.
    Using a sharp knife, cut completely through the end of the cable housing at the two locations.
  2. 3.
    Slide the large section of the cable housing out of the cable holder, being careful not to damage the cable stops.
  3. 4.
    Carefully remove the cut pieces of cable housing with a small flat tip screwdriver.
  4. 5.

    Hook the tip of the new control cable to the slider, then push the cable housing into the cable holder until it locks into place.

    NOTE: After assembly, check that the control dial turns smoothly through the full stroke from right to left.