Workshop manual

Heater Control Panel

Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 1049 (manual page 21-14)

PDF p. 1049 · 21-14

NOTE: LHD type is shown, RHD type is symmetrical.

  1. 1.
    Disconnect the air mix control cable and the mode control cable from the heater unit (See Page 21-20).
  2. 2.
    Remove the centre panel (see section 20)
  3. 3.
    Remove the self-tapping screws, then disconnect the connectors, and remove the heater control panel.
Illustration: CONNECTORS; HEATER CONTROL PANEL
  1. 1. CONNECTORS
  2. 2. HEATER CONTROL PANEL
  1. 4.
    Install in the reverse order of removal, and note these items:
    • Adjust the mode control (See Page 21-19) and the air mix control cable (See Page 21-20). If necessary, adjust the heater valve cable (See Page 21-20).
    • After installation, operate the heater control panel to see whether it works properly.