PDF p. 1654 · 4-44
The rear floor and rear floor cross-member are the base of the rear body and it is critical for the rigidity of the rear body. During replacement, refer to the body dimension chart or body correction chart and determine the position to set the rear floor, and rear floor cross-member, properly. Be sure that the rear floor is not bent or deformed. Weld securely, following the welder manufacturer's instructions to maintain the rigidity of the body.

- 1. Include 2 points of rear frame B
- 2. Include 3-plate welding of panhard rod bracket
- 3. Include 2 points of rear frame B
- 4. Tie down stiffener
- 5. Rear floor
- 6. Rear frame B
- 7. Rear frame C
- 8. Rear frame end gusset
- 9. Rear floor, Rear inner panel and Rear wheelhouse
- 10. Rear frame end gusset
- 11. Rear frame end gusset, Rear pillar stiffener and Outer panel
- 12. Rear frame C
- 13. Both sides, 6
- 14. Rear frame C and Rear frame B
- 15. Both sides, B
- 16. Rear floor cross-member and Rear frame B
- 17. Rear floor
- 18. Rear frame C and Rear frame B
- 19. Rear floor cross-member and rear frame B
- 20. Rear floor cross-member