PDF p. 921 · 19-B-17
NOTE: This operation can also be done with the Honda PGM Tester.
- 1.Connect the SCS short connector to the service check connector (2P) located passenger’s side of centre console.
- 2.Depress the brake pedal.
- 3.Turn the ignition switch ON (II) while keeping the brake pedal depressed. The ABS indicator goes off after two seconds.
- 4.After the indicator goes off, release the brake pedal. The indicator comes on after four seconds.
- 5.After the indicator comes on, depress the brake pedal again. (The indicator goes off again after four seconds. The brake pedal is still depressed.)
- 6.After the indicator goes off, release the brake pedal again.
- 7.After four seconds, the indicator blinks twice for 0.3 seconds and the DTC is cleared.
- 8.Confirm the DTC indication, and check that the DTC was cleared.
NOTE: Always maintain these steps. If you disconnect the SCS short connector and/or fail to operate the brake pedal according to the indicator indication, the DTC will not be erased.
Conditions for DTC clearing
- The vehicle is stopped.
- The SCS short connector is connected before the ignition switch is turned ON (II).
- The brake pedal is depressed before the ignition switch is turned ON (II).
- The SCS short connector remains connected during this procedure.
The DTC clearing stops and ABS control unit executes the software function if at least one of the following conditions is satisfied.
- The vehicle is not stopped.
- The SCS short connector is disconnected during this service.
- The ABS control unit receives the normal signal (which is for the ABS control unit) from a Honda PGM Tester.
- The brake pedal is not operated according to the indicator indication.
- The DTC clearing is finished.
