PDF p. 920 · 19-B-16
NOTE: This operation can also be done with the Honda PGM Tester.
- 1.Connect the SCS short connector to the service check connector (2P) located passenger’s side of centre console.
- 2.
Turn the ignition switch ON (II).
NOTE: Do not depress the brake pedal when turning the ignition switch.
- 3.Record the blinking frequency of the ABS indicator. The blinking frequency indicates the DTC.
- 4.
Turn the ignition switch OFF, and remove the SCS short connector.
NOTE: The Malfunction Indicator Lamp (MIL) will stay on after the engine is started if the SCS short connector is connected.
- 5.Clear the DTC.
Conditions for DTC indication
- The vehicle is stopped.
- The SCS short connector is connected before the ignition switch is turned ON (II).
- The brake pedal is released.
- The SCS short connector remains connected during this procedure.
The DTC indication stops and the ABS control unit executes the software function if at least one of the following conditions is satisfied:
- The vehicle is not stopped.
- The ABS control unit receives the normal signal (which is for the ABS control unit) from a Honda PGM Tester.
- The SCS short connector is disconnected during this procedure.

- 1. DATA LINK CONNECTOR (3P)
- 2. ABS INDICATOR
- 3. SERVICE CHECK CONNECTOR (2P)
- 4. SCS SHORT CONNECTOR, 07PAZ-0010100
