PDF p. 922 · 19-B-18
NOTE: This operation can also be done with the Honda PGM Tester.
| Detection Timing | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| DTC | ABS | Brake | Diagnosis/Symptom | Initial | Except | During | During | Problem | Refer to Page |
| Indicator | System | Diagnosis | ABS | ABS | Warning | Location | |||
| Indicator | Control | Control | |||||||
| No | - | ON | Brake system indicator does | - | - | - | - | (See Page | |
| DTC | not go off | 19-B-19) | |||||||
| No | OFF | - | ABS indicator does not | - | - | - | - | (See Page | |
| DTC | come on | 19-B-20) | |||||||
| No | ON | - | ABS indicator does not go | - | - | - | - | (See Page | |
| DTC | off. (No DTC) | 19-B-22) | |||||||
| 11 | ON*1 | ON*3 | Wheel sensor (open/short to | O | O | O | O | FR | (See Page |
| body ground/short to power) | 19-B-24) | ||||||||
| 13 | ON*1 | ON*3 | Wheel sensor (open/short to | O | O | O | O | FL | (See Page |
| body ground/short to power) | 19-B-24) | ||||||||
| 15 | ON*1 | ON*3 | Wheel sensor (open/short to | O | O | O | O | RR | (See Page |
| body ground/short to power) | 19-B-24) | ||||||||
| 17 | ON*1 | ON*3 | Wheel sensor (open/short to | O | O | O | O | RL | (See Page |
| body ground/short to power) | 19-B-24) | ||||||||
| 12 | ON*1 | ON*3 | Wheel sensor/Pulser | O | O | O | FR | (See Page | |
| (chipped pulser | 19-B-25) | ||||||||
| gear/electrical noise) | |||||||||
| 14 | ON*1 | ON*3 | Wheel sensor/Pulser | O | O | O | FL | (See Page | |
| (chipped pulser | 19-B-25) | ||||||||
| gear/electrical noise) | |||||||||
| 16 | ON*1 | ON*3 | Wheel sensor/Pulser | O | O | O | RR | (See Page | |
| (chipped pulser | 19-B-25) | ||||||||
| gear/electrical noise) | |||||||||
| 18 | ON*1 | ON*3 | Wheel sensor/Pulser | O | O | O | RL | (See Page | |
| (chipped pulser | 19-B-25) | ||||||||
| gear/electrical noise) | |||||||||
| 31 | ON | ON | Solenoid (open/short to | O | O | O | FR-IN | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 32 | ON | ON | Solenoid (open/short to | O | O | O | FR-OUT | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 33 | ON | ON | Solenoid (open/short to | O | O | O | FL-IN | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 34 | ON | ON | Solenoid (open/short to | O | O | O | FL-OUT | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 35 | ON | ON | Solenoid (open/short to | O | O | O | RR-IN | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 36 | ON | ON | Solenoid (open/short to | O | O | O | RR-OUT | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 37 | ON | ON | Solenoid (open/short to | O | O | O | RL-IN | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 38 | ON | ON | Solenoid (open/short to | O | O | O | RL-OUT | (See Page | |
| body ground/short to | 19-B-26) | ||||||||
| power/stuck) | |||||||||
| 51 | ON | OFF | Motor | O | O | (See Page | |||
| 19-B-27) | |||||||||
| 52 | ON | OFF | Motor stuck OFF | O | O | (See Page | |||
| 19-B-27) | |||||||||
| 53 | ON | OFF | Motor stuck ON | O | (See Page | ||||
| 19-B-27) | |||||||||
| 54*4 | ON | ON | Main relay stuck OFF | O | O | O | (See Page | ||
| 19-B-28) | |||||||||
| 61 | ON*2 | ON | Ignition voltage (low | O | O | O | O | (See Page | |
| voltage/high voltage) | 19-B-29) | ||||||||
| 81 | ON | ON | Hardware failure | O | O | O | O | (See Page | |
| 19-B-30) | |||||||||
| 81*5 | ON | ON | Disturbance detection | O | O | O | (See Page | ||
| 19-B-30) | |||||||||
- *1:If DTCs 11-18 (wheel sensor codes) were detected the last time the vehicle was driven, the ABS indicator will stay on until the ignition switch is turned ON (II), and the control unit confirms that the wheel sensors are OK.
- *2:The ABS indicator goes off if the ignition voltage returns to normal.
- *3:The brake system indicator comes on when the ABS control unit detects more than one wheel problem.
- *4:This code is indicated only when the Honda PGM Tester is used.
- *5:Failure code of communication mode for the Honda PGM Tester is 82.