Workshop manual

Troubleshooting Procedures

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 919 (manual page 19-B-15)

PDF p. 919 · 19-B-15

Kickback

  1. 1.
    The motor operates when the ABS is functioning, and the fluid in the reservoir is forced out to the master cylinder, causing kickback at the brake pedal.
  2. 2.
    The ABS control unit operates the solenoid valve when the brake pedal is released after the initial diagnosis. You may hear the solenoid valve operate at this time, but it is normal. Pump Motor
  3. 1.
    The pump motor operates when the ABS is functioning
  4. 2.
    The ABS control unit checks the pump motor operation once or twice in every ignition switch ON (II) operation while vehicle acceleration. You may hear the motor operate at this time, but it is normal.

Brake Fluid Replacement/Air Bleeding

  1. 1.
    Brake fluid replacement and air bleeding procedures are the same as vehicles without ABS. To ease bleeding, start with the front wheels.

Troubleshooting

  1. 1.
    The troubleshooting flowcharts procedures assume that the cause of the problem is still present and the ABS indicator is still on. Following the flowchart when the ABS indicator dose not come on can result in incorrect diagnosis.
  2. 2.

    Question the customer about the conditions when the problem occurred, and try to reproduce the same conditions for troubleshooting.

    Self-diagnosis is made at various times such as the initial diagnosis, except ABS control, during ABS control, during acceleration, during the specified vehicle speed, etc. Therefore, the symptom, cannot be checked unless the check conditions match with the problem conditions.

  3. 3.
    When the ABS indicator does not come on during the test-drive, but troubleshooting is performed based on the DTC, check the loose connectors, poor contact of the terminals, etc., before you start troubleshooting.
  4. 4.
    After troubleshooting, clear the DTC and test-drive the vehicle. Be sure the ABS indictor does not come on.
  5. 5.
    The connector illustrations show the female terminals with a single outline and the male terminals with a double outline.

ABS Function Test

To simulate ABS operation and activate the solenoid valves and pump, use the Honda PGM Tester.

Connect the PGM Tester to the 3P Data Link Connector (DLC). When the System Select menu is displayed, select the ABS Test Mode menu and follow the tester’s prompts.