Workshop manual

Troubleshooting Precautions

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 918 (manual page 19-B-14)

PDF p. 918 · 19-B-14

ABS Indicator

  1. 1.
    If the system is OK, the ABS indicator goes off two seconds after turning the ignition switch ON (II) without starting the engine, and then comes on again and goes off after two seconds. This occurs because the ABS control unit is turned on by the IG2 power source.
  2. 2.
    The ABS indicator comes on when the ABS control unit detects a problem in the system. However, even thought the system is operating properly, the ABS indicator will come on too, under the following conditions.
    • Signal disturbance
    • Wheel spin
    • Only drive wheels rotate
    • Battery voltage fluctuates

To determine the actual cause of the problem, question the customer about the problem, taking these conditions into consideration.

  1. 3.
    When a problem is detected and the ABS indicator comes on, there are cases when the indicator light stays on until the ignition switch is turned OFF, and cases when the indicator light goes off automatically when the system returns to normal. For DTC 61, the indicator goes off automatically when the system returns to normal. For all other codes, the indicator stays on until the ignition switch is turned OFF.
  2. 4.

    The ABS indicator stays on when the system is reactivated without erasing the DTC, but it goes off after starting the vehicle.

    When the wheel sensor system is faulty and the ABS indicator comes on, the algorithm of the system automatically turns off the ABS indicator after the wheel speed signal returns to the normal speed. Also, when the DTC is erased, the CPU is reset and the ABS indicator goes off when the system checked out normal by the initial diagnosis.

    Therefore, test-drive the vehicle after servicing the wheel sensor system, and be sure that the ABS indicator does not come on.

  3. 5.
    When the ABS control unit outputs battery voltage to gauge assembly, the ABS indicator goes off.

Diagnostic Trouble Code (DTC)

  1. 1.

    The diagnostic trouble code (DTC is memorised when a problem is detected and the ABS indicator does not go off, or when the ABS indicator comes on.

    The DTC is not memorised when the ABS indicator comes on unless the CPU is activated.

  2. 2.

    The memory can hold any number of DTC. However, when the same DTC is detected twice or more, the later one is written over the old one.

    Therefore, when the same problem is detected repeatedly, it is recorded as one DTC.

  3. 3.
    The DTCs are indicated in the order of ascending number, not in the order they occur.
  4. 4.

    The DTCs are memorised in the EEPROM (non-volatile memory).

    Therefore, the memorised DTCs cannot be cancelled by disconnecting the battery. Perform the specified procedures to clear the DTCs.

Self-diagnosis

  1. 1.

    Self-diagnosis can be classified into these four categories:

    ♦ Initial diagnosis:Performed right after the engine starts and until the ABS indicator goes off.
    ♦ Except ABS control:Performed when the ABS is not functioning.
    ♦ During ABS control:Performed when the ABS is functioning.
    ♦ During warning:Performed when the ABS indicator is ON.
  2. 2.
    The system performs the following controls when a problem is detected by the self-diagnosis.
    • ABS indicator ON
    • Memory of DTC
    • Stops ABS control