Workshop manual

Brake Hose and Line

Brake Hose Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 903 (manual page 19-A-26)

PDF p. 903 · 19-A-26

NOTE:

  • Before reassembling check that all parts are free of dust and other foreign particles.
  • Replace parts with new ones whenever specified to do so.
  • Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
  1. 1.
    Replace the brake hoses if the hose is twisted, cracked or if it leaks.
  2. 2.
    Disconnect the brake hose from the brake line using a 10 mm flare nut wrench.
Illustration: BRAKE LINE; FLARE NUT WRENCH; BRAKE HOSE
  1. 1. BRAKE LINE
  2. 2. FLARE NUT WRENCH
  3. 3. BRAKE HOSE
  1. 3.
    Remove and discard the brake hose clip from the brake hose.
Illustration: BRAKE HOSE; BRAKE HOSE CLIP, Replace; 6 mm HOSE BRACKET BOLTS; BANJO BOLT
  1. 1. BRAKE HOSE
  2. 2. BRAKE HOSE CLIP, Replace
  3. 3. 6 mm HOSE BRACKET BOLTS
  4. 4. BANJO BOLT
  1. 4.
    Remove the banjo bolt and disconnect the brake hose from the caliper.
  2. 5.
    Remove the brake hose from the knuckle and always replace the bracket and hose with new ones.
  1. 6.
    Install the brake hose bracket and brake hose on the knuckle first, then connect the brake hose tot he caliper with the banjo bolt and new sealing washers.
Illustration: BANJO BOLT, 34 Nm (3.5 kgf/m, 25 lbf/ft); BRAKE HOSE; BRAKE HOSE BRACKET; 6 mm HOSE BRACKET BOLTS, 9.8 Nm (1.0 kgf/m, 7 lbf/ft); SEALING WASHERS, Replace
  1. 1. BANJO BOLT, 34 Nm (3.5 kgf/m, 25 lbf/ft)
  2. 2. BRAKE HOSE
  3. 3. BRAKE HOSE BRACKET
  4. 4. 6 mm HOSE BRACKET BOLTS, 9.8 Nm (1.0 kgf/m, 7 lbf/ft)
  5. 5. SEALING WASHERS, Replace
  1. 7.
    Install the brake hose on the brake hose bracket with a new brake hose clip.
Illustration: 15 Nm (1.5 kgf/m, 11 lbf/ft); BRAKE HOSE; BRAKE HOSE CLIP, Replace
  1. 1. 15 Nm (1.5 kgf/m, 11 lbf/ft)
  2. 2. BRAKE HOSE
  3. 3. BRAKE HOSE CLIP, Replace
  1. 8.
    Connect the brake line to the brake hose.
  2. 9.
    After installing the brake hose, bleed the brake system (See Page 19-A-7).
  3. 10.
    Perform the following checks:
    • Check the brake hose and line joint for leaks and tighten if necessary.
    • Check the brake hoses for interference or twisting.