Workshop manual

Parking Brake Cable

Inspection/Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 904 (manual page 19-A-27)

PDF p. 904 · 19-A-27

NOTE: The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature cable failure.

Illustration · Parking Brake Cable · Inspection/Replacement
  1. 1.
    Remove the brake shoes (See Page 19-A-22), and disconnect the parking brake cable from the parking brake lever.
  2. 2.
    Remove the clip from the cable holder on the backing plate.
  3. 3.
    Remove the parking brake cable end from the backing plate.
  4. 4.
    Insert the parking brake into the cable holder and connect the cable end on the parking brake lever.
  5. 5.
    Align the cutout in the cable holder with the tab on the cable. Install the clip in the cable holder groove. Make sure that the round side of the clip is to the outside (backing plate side).
  1. 1.

    PARKING BRAKE LEVER

    Check for smooth operation

  2. 2.

    PARKING BRAKE CABLE

    Check for faulty movement

  3. 3.
    CLIP
  4. 4.
    ADJUSTING NUT
  5. 5.
    EQUALISER
  6. 6.
    PARKING BRAKE SWITCH
  7. 7.
    (Sliding surface)
  8. 8.
    CLIP
  9. 9.
    Round side
  10. 10.
    CABLE HOLDER
  11. 11.
    PARKING BRAKE CABLE
  12. 12.
    CUTOUT
  13. 13.
    TAB