Workshop manual

Master Cylinder/Brake Booster

Disassembly

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 891 (manual page 19-A-14)

PDF p. 891 · 19-A-14

  1. 1.
    Remove the master cylinder (See Page 19-A-13).
  2. 2.
    Remove the rod seal from the brake booster side.
  3. 3.
    Remove the circlip while pushing in the secondary piston.
Illustration: ROD SEAL, Replace; CIRCLIP, Replace; SECONDARY PISTON
  1. 1. ROD SEAL, Replace
  2. 2. CIRCLIP, Replace
  3. 3. SECONDARY PISTON
  1. 4.
    Remove the secondary piston and primary piston from master cylinder.
Illustration: PRIMARY PISTON, Replace; SECONDARY PISTON, Replace
  1. 1. PRIMARY PISTON, Replace
  2. 2. SECONDARY PISTON, Replace
  1. 5.
    Remove the reservoir cap and strainer from the reservoir.
  2. 6.
    Remove the reservoir seal from the reservoir cap.
Illustration: RESERVOIR SEAL, Check for damage and deterioration; RESERVOIR CAP, Check for blockages of vent holes; STRAINER, Remove accumulated sediment; RESERVOIR, Check for damage; MASTER CYLINDER, Check bore for wear, rust and damage; GROMMETS, Replace
  1. 1. RESERVOIR SEAL, Check for damage and deterioration
  2. 2. RESERVOIR CAP, Check for blockages of vent holes
  3. 3. STRAINER, Remove accumulated sediment
  4. 4. RESERVOIR, Check for damage
  5. 5. MASTER CYLINDER, Check bore for wear, rust and damage
  6. 6. GROMMETS, Replace
  1. 7.

    Remove the reservoir and grommets.

    NOTE: When the reservoir and master cylinder body are separated, replace the grommets with new ones.