PDF p. 888 · 19-A-11
- 1.Loosen the front wheel nuts slightly, then raise the vehicle and support on safety stands. Remove the front wheels.
- 2.Remove the brake pads (See Page 19-A-9).
- 3.Inspect the disc surface for damage or cracks. Clean the disc thoroughly and remove all rust.
- 4.
Use wheel nuts and suitable plain washers to hold the disc securely against the hub, then mount a dial indicator as shown and measure the runout at 10 mm (0.4 in) from the edge of the disc.
Brake Disc Runout:
Service Limit: 0.10 mm (0.004 in)
- 5.
If the disc is beyond the service limit, refinish the brake disc with an on-car brake lathe. The Kwik-Lathe produced by Kwik-way manufacturing Co. and the “Front Brake Disc Lathe” offered by Snap on Tools Co. are approved for this operation.
Max Refinish Limit: 21.0 mm (0.83 in)

- 1. 10 mm (0.4 in)
- 2. WHEEL NUT AND PLAIN WASHER, 108 Nm (11 kgf/m, 79.6 lbf/ft)
NOTE: A new disc should be refinished if its runout is greater than 0.10 mm (0.004 in).
Disc Thickness and Parallelism Inspection
- 1.Loosen the front wheel nuts slightly, then raise the vehicle and support on safety stands. Remove the front wheels.
- 2.Remove the brake pads (See Page 19-A-9).
- 3.Using a micrometer, measure disc thickness at eight points, approximately 45° apart and 10 mm (0.4 in) in from the outer edge of the disc. Replace the brake disc if the smallest measurement is less than the max. refinishing limit.

- 1. 10 mm (0.4 in)
Brake Disc Thickness:
Standard:
22.9 - 23.1 mm (0.90 - 0.91 in)
Max Refinishing Limit: 21.0 mm (0.83 in)
Brake Disc Parallelism: 0.015 mm (0.0006 in) max
- 4.
If the disc is beyond the service limit for parallelism, refinish the brake disc with an on-car brake lathe. The Kwik-Lathe produced by Kwik-way manufacturing Co. and the “Front Brake Disc Lathe” offered by Snap on Tools Co. are approved for this operation.
NOTE: See section 18 for brake disc replacement.