Workshop manual

Inspection and Adjustment

Parking Brake

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 883 (manual page 19-A-6)

PDF p. 883 · 19-A-6

Inspection

  1. 1.
    Pull the parking brake lever with 196 N (20 kgf, 44 lbf) force to fully apply the parking brake. The parking brake lever should be located within the specified notches. Lever Locked Notches: 7 - 10
Illustration: PARKING BRAKE LEVER; Pulled up with 196 N (20 kgf, 44 lbf); LEVER LOCKED NOTCHES
  1. 1. PARKING BRAKE LEVER
  2. 2. Pulled up with 196 N (20 kgf, 44 lbf)
  3. 3. LEVER LOCKED NOTCHES
  1. 2.
    Adjust the parking brake if the lever notches are out of specification.

Adjustment

NOTE: After rear brake shoes servicing, loosen the parking brake adjusting nut, start the engine and depress the brake pedal several times to set the self-adjusting brake before adjusting the parking brake.

  1. 1.
    Raise the rear wheels off the ground and support on safety stands. Block the front wheels before jacking up the rear of the vehicle.
  2. 2.
    Remove the rear console (see section 20).
  3. 3.
    Pull the parking brake lever up on notch.
  4. 4.
    Tighten the adjusting nut until the parking brakes drag slightly when the rear wheels are turned.
Illustration: ADJUSTING NUT
  1. 1. ADJUSTING NUT
  1. 5.
    Release the parking brake lever fully and check that the parking brakes do not drag when the rear wheels are turned. readjust as necessary.
  2. 6.
    Make sure the parking brakes are fully applied when the parking brake lever is pulled up fully.
  3. 7.
    Reinstall the rear console.