Workshop manual

Inspection and Adjustment

Brake Pedal

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 882 (manual page 19-A-5)

PDF p. 882 · 19-A-5

Pedal Height

  1. 1.
    Disconnect the brake switch connector, loosen the brake switch locknut and back off the brake switch until it is no longer touching the brake pedal.
  2. 2.
    Pull back the carpet and measure the pedal height from the left side centre of the pedal pad.
Illustration: PUSHROD LOCKNUT; BRAKE SWITCH LOCKNUT; BRAKE SWITCH; Centre; MEASURING POINT (Cutout); PEDAL HEIGHT; FLOOR PANEL
  1. 1. PUSHROD LOCKNUT
  2. 2. BRAKE SWITCH LOCKNUT
  3. 3. BRAKE SWITCH
  4. 4. Centre
  5. 5. MEASURING POINT (Cutout)
  6. 6. PEDAL HEIGHT
  7. 7. FLOOR PANEL

Standard Pedal Height (with floor mat removed):

M/T: 192 mm (7.56 in)

A/T: 197 mm (7.76 in)

  1. 3.
    Loosen the pushrod locknut and screw the pushrod in or out with pliers until the standard pedal height from the floor is reached. After adjustment, tighten the locknut firmly. Do not adjust the pedal height with the pushrod depressed.
Illustration: Lower the pedal; Raise the pedal; PUSHROD LOCKNUT, 15 Nm (1.5 kgf/m, 11 lbf/ft)
  1. 1. Lower the pedal
  2. 2. Raise the pedal
  3. 3. PUSHROD LOCKNUT, 15 Nm (1.5 kgf/m, 11 lbf/ft)
  1. 4.
    Screw in the brake switch until its plunger is fully depressed (threaded end touching the pad on the pedal arm). Then back off the switch 1/4 turn to make 0.3 mm (0.01 in) of clearance between the threaded end and pad. Tighten the locknut firmly. Connect the brake switch connector. Make sure that the brake lights go off when the pedal is released.
Illustration: PAD; Threaded end; 0.3 mm (0.01 in)
  1. 1. PAD
  2. 2. Threaded end
  3. 3. 0.3 mm (0.01 in)
  1. 5.
    Check the brake pedal free play as described below.

Pedal Free Play

  1. 1.

    Stop the engine and inspect the pedal free play on the pedal pad by pushing the pedal by hand.

    Free Play: 1- 5 mm (0.04 - 0.20 in)

  2. 2.
    If the pedal free play is out of specification, adjust the brake switch. If the pedal free play is insufficient, it may result in brake drag.
Illustration: BRAKE PEDAL PIN; PEDAL FREE PLAY
  1. 1. BRAKE PEDAL PIN
  2. 2. PEDAL FREE PLAY