Workshop manual

Wheel Alignment

Wheel Runout

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 860 (manual page 18-7)

PDF p. 860 · 18-7

  1. 1.
    Raise the vehicle off the ground and support it with safety stands in the proper locations (see section 1).
  2. 2.
    Check for bent or deformed wheels.
  3. 3.
    Attach the dial gauge as shown.
  4. 4.

    Measure the wheel runout by turning the wheel.

    Front and Rear Wheel Axial Runout:

    Standard:

    Steel Wheel:0 - 1.0 mm (0 - 0.04 in)
    Aluminium Wheel: 0 - 0.7 mm (0 - 0.03 in)
    Service Limit:2.0 mm (0.08 in)
Illustration · Wheel Alignment · Wheel Runout

Front and Rear Wheel Radial Runout:

Standard:

Steel Wheel:0 - 1.0 mm (0 - 0.04 in)
Aluminium Wheel:0 - 0.7 mm (0 - 0.03 in)
Service Limit:1.5 mm (0.06 in)
Illustration · Standard
  1. 5.
    If the wheel runout is more than the service limit, replace the wheel.