Workshop manual

Wheel Alignment

Turning Angle Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 859 (manual page 18-6)

PDF p. 859 · 18-6

  1. 1.
    Jack up the front of the vehicle. Set the turning radius gauges beneath the front wheels, then lower the vehicle.
  2. 2.

    Jack up the rear of the vehicle. Place boards that are the same thickness as the turning radius gauges under the rear wheels, then lower the vehicle.

    NOTE: For accurate readings the vehicle must be level.

  3. 3.

    Turn the wheel right and left while applying the brake and measure the turning angle of both wheels.

    Turning angle:

    Inward wheel:38°00’ ± 2°
    Outward wheel:30°00’ (reference)
Illustration: TURNING RADIUS GAUGE
  1. 1. TURNING RADIUS GAUGE
  1. 4.

    If the measurements are not within the specification, adjust as required by turning the tie-rods.

    NOTE: After adjustment, recheck the front wheel toe and readjust if necessary. Reposition the tie-rod boot if twisted or displaced.

Illustration: TIE ROD LOCKNUT, 12 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft); TIE-ROD
  1. 1. TIE ROD LOCKNUT, 12 x 1.25 mm, 44 Nm (4.5 kgf/m, 33 lbf/ft)
  2. 2. TIE-ROD

Bearing End Play

  1. 1.
    Raise the vehicle off the ground and support it with safety stands in the proper locations (see section 1).
  2. 2.
    Remove the wheels then reinstall the wheel nuts.
  3. 3.
    Attach the dial gauge as shown.
  4. 4.

    Measure the bearing end play by moving the disc in or outward.

    Front/Rear:

    Standard: 0 - 0.05 mm (0 - 0.002 in)

    Front

Illustration: Measure end play at the hub flange; 108 Nm (11 kgf/m, 80 lbf/ft)
  1. 1. Measure end play at the hub flange
  2. 2. 108 Nm (11 kgf/m, 80 lbf/ft)

Rear

Illustration: 108 Nm (11 kgf/m, 80 lbf/ft); Measure end play at the hub flange
  1. 1. 108 Nm (11 kgf/m, 80 lbf/ft)
  2. 2. Measure end play at the hub flange
  1. 5.
    If the bearing end play measurement is more than the standard, replace the wheel bearing.