Workshop manual

Inspection and Adjustment

Fluid Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 813 (manual page 17-18)

PDF p. 813 · 17-18

Check the reservoir at regular intervals, and add fluid as necessary.

SYSTEM CAPACITY:

LHD: 0.61 litre (0.64 US. qt. 0.54 lmp.qt) at disassembly RHD: 0.65 litre (0.70 US. qt, 0.57 lmp.qt) at disassembly

Illustration: RESERVOIR; UPPER LEVEL LINE; LOWER LEVEL LINE
  1. 1. RESERVOIR
  2. 2. UPPER LEVEL LINE
  3. 3. LOWER LEVEL LINE
  1. 1.
    Raise the reservoir and disconnect the return hose to drain the reservoir. Take care not to spill the fluid on the body and parts. Wipe off spilled fluid at once.
Illustration: RETURN HOSE; HOSE
  1. 1. RETURN HOSE
  2. 2. HOSE
  1. 2.
    Connect a hose of suitable diameter to the disconnected return hose, and put the hose end in a suitable container.
  2. 3.
    Start the engine, let it run at idle, and turn the steering wheel from lock-to-lock several times. When fluid stops running out of the hose, shut off the engine. Discard the fluid.
  3. 4.
    Refit the return hose on the reservoir.
  4. 5.
    Fill the reservoir to the upper level line.
  5. 6.
    Start the engine and run it at fast idle, then turn the steering from lock-to-lock several times to bleed air from the system
  6. 7.
    Recheck the fluid level and add some if necessary. Do not fill the reservoir beyond the upper level line.