PDF p. 1940 · 14-9
A/T Control System - KQ and KU Models with D16W5 Engine (cont’d)
PCM CONNECTOR D (16P)
| Terminal | Signal | Description | Measuring Conditions/Terminal Voltage |
|---|---|---|---|
| Number | |||
| D1 | VEL | Secondary gear shaft speed | Depending on vehicle speed: Pulsing signal |
| sensor signal input | When vehicle is stopped: Approx. 0 V | ||
| D2 | SOL INH | Inhibitor solenoid control | With inhibitor solenoid ON: Battery voltage |
| With inhibitor solenoid OFF: 0 V | |||
| D3 | SH LSM | Shift control linear solenoid power | |
| supply negative electrode | |||
| D4 | SH LSP | Shift control linear solenoid power | With ignition switch ON (II): Pulsing signal |
| supply positive electrode | |||
| D5 | VB SOL | Power supply for solenoid valves | With ignition switch ON (II): Battery voltage |
| With ignition switch OFF: 0 V | |||
| D6 | ATP R | A/T gear position switch R | In R position: 0 V |
| position input | In other than R position: Approx. 10 V | ||
| D7 | VEL SG | Secondary gear shaft speed | |
| sensor ground | |||
| D8 | S2 IND | With S2 mode switch ON and | |
| on: Battery voltage | |||
| D9 | D SW | D mode switch signal input | With D mode switch ON: 0 V |
| With D mode switch OFF: Approx. 5 V | |||
| D10 | NDN | Driven pulley speed sensor signal | In other than P and N position: Pulsing signal |
| input | |||
| D11 | NDR | Drive pulley speed sensor signal | In other than P and N position: Pulsing signal |
| input | |||
| D12 | NDR SG | Drive pulley speed sensor ground | |
| D13 | S SW | S1 or S2 mode switch signal input | With S mode switch ON: 0 V |
| With S mode switch OFF: Approx. 5 V | |||
| D14 | S IND | With S1 mode switch ON and | |
| on: Battery voltage | |||
| D15 | D IND | D Indicator light control | When ignition switch is first turned ON (II): Battery |
| voltage for two seconds | |||
| In D position: Battery voltage | |||
| D16 | NDN SG | Driven pulley speed sensor ground |