Workshop manual

Intermediate Shaft

Reassembly

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 791, 792 (manual pages 16-32 to 16-33)

PDF p. 791 · 16-32

NOTE:

  • Clean the disassembled parts with solvent and dry them thoroughly with compressed air. Do not wash the rubber parts with solvent.
  • Be careful not to damage the metal rings on the intermediate shaft during reassembly.
Illustration: INTERMEDIATE SHAFT; BEARING SUPPORT RING; EXTERNAL CIRCLIP; DOWEL BOLTS, 10 x 1.25 mm, 39 Nm (4.0 kgf/m, 29 lbf/ft); SET RING, Replace; OUTER SEAL, Replace Pack the interior of the outer seal; BEARING SUPPORT; INTERMEDIATE SHAFT BEARING, Replace; INTERNAL CIRCLIP; INTERMEDIATE SHAFT RING
  1. 1. INTERMEDIATE SHAFT
  2. 2. BEARING SUPPORT RING
  3. 3. EXTERNAL CIRCLIP
  4. 4. DOWEL BOLTS, 10 x 1.25 mm, 39 Nm (4.0 kgf/m, 29 lbf/ft)
  5. 5. SET RING, Replace
  6. 6. OUTER SEAL, Replace
    Pack the interior of the outer seal
  7. 7. BEARING SUPPORT
  8. 8. INTERMEDIATE SHAFT BEARING, Replace
  9. 9. INTERNAL CIRCLIP
  10. 10. INTERMEDIATE SHAFT RING

PDF p. 792 · 16-33

  1. 1.
    Press the intermediate shaft bearing into the bearing support using the special tools and a press as shown.
Illustration: DRIVER ATTACHMENT, 52 x 55 mm, 07746-0010400; Press; DRIVER, 07749-0010000; BEARING
  1. 1. DRIVER ATTACHMENT, 52 x 55 mm, 07746-0010400
  2. 2. Press
  3. 3. DRIVER, 07749-0010000
  4. 4. BEARING
  1. 2.
    Seat the internal circlip in the groove of the bearing support.
  2. 3.
    Press the intermediate shaft into the shaft bearing using the special tools and a press.
Illustration: INTERNAL CIRCLIP; Press; INTERMEDIATE SHAFT; DRIVER ATTACHMENT, 35 mm I.D., 07746-0030400
  1. 1. INTERNAL CIRCLIP
  2. 2. Press
  3. 3. INTERMEDIATE SHAFT
  4. 4. DRIVER ATTACHMENT, 35 mm I.D., 07746-0030400
  1. 4.
    Seat the external circlip in the groove of the intermediate shaft.
  2. 5.

    Install the outer seal into the bearing support using the special tools as shown.

    NOTE: Install the seal flush with the bearing support.

Illustration: OUTER SEAL, Replace; Pack the interior of the outer seal; Press; DRIVER, 07749-0010000; DRIVER ATTACHMENT, 52 x 55 mm, 07746-0010400; INNER RACE DRIVER, 07LAD-PW50601; EXTERNAL CIRCLIP
  1. 1. OUTER SEAL, Replace
  2. 2. Pack the interior of the outer seal
  3. 3. Press
  4. 4. DRIVER, 07749-0010000
  5. 5. DRIVER ATTACHMENT, 52 x 55 mm, 07746-0010400
  6. 6. INNER RACE DRIVER, 07LAD-PW50601
  7. 7. EXTERNAL CIRCLIP