Workshop manual

Intermediate Shaft

Disassembly

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 790 (manual page 16-31)

PDF p. 790 · 16-31

NOTE: Be careful not to damage the metal rings on the intermediate shaft during disassembly.

  1. 1.
    Remove the set ring.
  2. 2.
    Remove the intermediate shaft outer seal from the bearing support.
  3. 3.
    Remove the external circlip.
Illustration: BEARING SUPPORT; EXTERNAL CIRCLIP; SET RING, Replace; OUTER SEAL, Replace
  1. 1. BEARING SUPPORT
  2. 2. EXTERNAL CIRCLIP
  3. 3. SET RING, Replace
  4. 4. OUTER SEAL, Replace
  1. 4.
    Press the intermediate shaft out of the shaft bearing using the special tools and a press as shown.
Illustration: BEARING SUPPORT Check for damage; Press; INTERNAL CLIP; HALF SHAFT BASE, 07NAF-SR30101; INTERMEDIATE SHAFT Check for damage; BEARING SUPPORT RING Check for damage or distortion
  1. 1. BEARING SUPPORT
    Check for damage
  2. 2. Press
  3. 3. INTERNAL CLIP
  4. 4. HALF SHAFT BASE, 07NAF-SR30101
  5. 5. INTERMEDIATE SHAFT
    Check for damage
  6. 6. BEARING SUPPORT RING
    Check for damage or distortion
  1. 5.
    Remove the internal circlip.
  1. 6.
    Press the intermediate shaft bearing out of the bearing support using the special tools and a press as shown.
Illustration: BEARING; DRIVER ATTACHMENT, 42 x 47 mm, 07746-0010300; Press; DRIVER, 07749-0010000; HALF SHAFT BASE, 07NAF-SR30101
  1. 1. BEARING
  2. 2. DRIVER ATTACHMENT, 42 x 47 mm, 07746-0010300
  3. 3. Press
  4. 4. DRIVER, 07749-0010000
  5. 5. HALF SHAFT BASE, 07NAF-SR30101