Workshop manual

Propeller Shaft

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 793 (manual page 16-34)

PDF p. 793 · 16-34

  1. 1.
    Shift into the neutral position (M/T or N position (A/T).
  2. 2.
    Raise the vehicle off the ground and support it with safety sands in the proper locations (see section 1).
  3. 3.
    Check the centre support bearing for excessive play or rattle. If the centre support has excessive play or rattle, replace the propeller shaft assembly.
  4. 4.
    Check the universal joint boots for damage and deterioration. If the boots are damaged or deteriorated, replace the propeller shaft assembly.
  5. 5.
    Check the universal joints for excessive play or rattle. If the universal joints have excessive play or rattle, replace the propeller shaft assembly.
  6. 6.
    Install a dial indicator with its needle on the centre of the front or rear propeller shaft.
  7. 7.

    Turn the other propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.

    Runout:

    Service Limit: 1.5 mm (0.06 in)

    Front Propeller Shaft:

Illustration · Propeller Shaft · Inspection

Rear Propeller Shaft:

Illustration · Rear Propeller Shaft
  1. 8.
    If the runout on either propeller shaft exceeds the service limit, replace the propeller shaft assembly.