PDF p. 789 · 16-30
- 1.Drain the MTF (see section 13) or ATF (see section 14).
- 2.Remove the left driveshaft (See page 16-3).
- 3.Remove the three dowel bolts.
- 4.Remove the intermediate shaft from the differential. Hold the intermediate shaft horizontal until it is clear of the differential to prevent damage to the differential oil seal.

- 1. DOWEL BOLTS, 10 x 1.25 mm
- 2. INTERMEDIATE SHAFT
Installation
- 1.Clean the areas where the intermediate shaft contacts the transmission (differential) thoroughly with solvent or carburettor cleaner and dry with compressed air. Insert the intermediate shaft assembly into the differential. Hold the intermediate shaft horizontal to prevent damage to the differential oil seal.
- 2.Install the three dowel bolts, then tighten them.

- 1. DOWEL BOLTS, 10 x 1.25 mm, 39 Nm (4.0 kgf/m, 29 lbf/ft)
- 2. INTERMEDIATE SHAFT
- 3.Refill the transmission with recommended MTF (see section 13) or ATF (see section 14).