Workshop manual

Maintenance

Differential Fluid

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 745 (manual page 15-14)

PDF p. 745 · 15-14

  1. 1.
    With the vehicle on level ground, inspect the differential fluid with the engine OFF.
  2. 2.
    Remove the oil filler plug, then check the level and condition of the fluid.
Illustration: WASHER, Replace; Proper level; OIL FILLER PLUG, 47Nm (4.8 kgf/m, 35 lbf/ft)
  1. 1. WASHER, Replace
  2. 2. Proper level
  3. 3. OIL FILLER PLUG, 47Nm (4.8 kgf/m, 35 lbf/ft)
  1. 3.
    The fluid level must be up to the fill hole. If it is below the hole, add the recommended fluid until it runs out, then reinstall the oil filler plug with a new washer.
  2. 4.
    If the differential fluid is dirty, remove the drain plug and drain the fluid.
Illustration: WASHER, Replace; OIL FILLER PLUG, 47 Nm (4.8 kgf/m, 35 lbf/ft); WASHER, Replace; DRAIN PLUG, 47 Nm (4.8 kgf/m, 35 lbf/ft)
  1. 1. WASHER, Replace
  2. 2. OIL FILLER PLUG, 47 Nm (4.8 kgf/m, 35 lbf/ft)
  3. 3. WASHER, Replace
  4. 4. DRAIN PLUG, 47 Nm (4.8 kgf/m, 35 lbf/ft)
  1. 5.

    Clean the drain plug, the fit it with a new washer and refill the differential with the recommended fluid to the proper level.

    NOTE: If you disassemble the differential, check the fluid level again after the 4WD system check is finished. Add fluid if necessary.

  2. 6.

    Reinstall the oil filler plug with a new washer.

    Fluid Capacity

    1.0 L (1.1 US qt, 0.9 Imp qt) at fluid change 1.2 L (1.3 US qt, 1.1 Imp qt) at overhaul Recommended fluid:

    Genuine Honda ATF PREMIUM (Automatic Transmission Fluid-PREMIUM)