Workshop manual

Real-time 4WD-Dual Pump System

Troubleshooting

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 741, 742, 743 (manual pages 15-10 to 15-12)

PDF p. 741 · 15-10

When starting and accelerating in forward gears (4WD mode)

Manual Transmission:

  1. 1.
    Lift up the vehicle so all four wheels are off the ground (see section 1).
Illustration · Manual Transmission
  1. 2.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice)
  2. 3.
    With the engine at idle, shift into 1st gear and release the clutch.
  3. 4.
    Apply the parking brake firmly.
    • If the engine stalls, the 4WD system is normal.
    • If the engine continues running, there is a problem in 4WD system. Check the differential fluid. If the differential fluid is normal, replace the torque control differential case kit.

Automatic Transmission:

  1. 1.
    Lift up the vehicle so all four wheels are off the ground (see section 1).
Illustration · Automatic Transmission
  1. 2.
    Make a mark on either front or rear propeller shaft.
Illustration: PROPELLER SHAFT; Mark
  1. 1. PROPELLER SHAFT
  2. 2. Mark
  1. 3.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice).
  2. 4.
    With the engine at idle, shift to the 1 position.
  3. 5.
    Apply the parking brake firmly and measure the time it takes the propeller shaft to rotate 10 times.
    • If the measured time is more than 10 seconds the 4WD system is normal.
    • If the time is less than 10 seconds, there is a problem in 4WD system. Check the differential fluid. If the differential fluid is normal, replace the torque control differential case kit.

PDF p. 742 · 15-11

When starting and accelerating in reverse gear (4WD mode)

Manual Transmission:

  1. 1.
    Lift up the vehicle so all four wheels are off the ground (see section 1).
Illustration · Manual Transmission
  1. 2.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice)
  2. 3.
    With the engine at idle, shift into reverse gear and release the clutch.
  3. 4.
    Apply the parking brake firmly.
    • If the engine stalls, the 4WD system is normal.
    • If the engine continues running, there is a problem in 4WD system. Check the differential fluid. If the differential fluid is normal, replace the torque control differential case kit.

Automatic Transmission:

  1. 1.
    Lift up the vehicle so all four wheels are off the ground (see section 1).
Illustration · Automatic Transmission
  1. 2.
    Make a mark on either front or rear propeller shaft.
Illustration: PROPELLER SHAFT; Mark
  1. 1. PROPELLER SHAFT
  2. 2. Mark
  1. 3.
    Start the engine and let it run until it warms up (the radiator fan comes on at least twice).
  2. 4.
    With the engine at idle, shift to the R position.
  3. 5.
    Apply the parking brake firmly and measure the time it takes the propeller shaft to rotate 10 times.
    • If the measured time is more than 10 seconds the 4WD system is normal.
    • If the time is less than 10 seconds, there is a problem in 4WD system. Check the differential fluid. If the differential fluid is normal, replace the torque control differential case kit.

PDF p. 743 · 15-12

When decelerating in a forward gear (2WD mode)

  1. 1.
    Block the front wheels, raise the left rear wheel and support it with a safety stand as shown.
Illustration: WHEEL CHOCKS; SAFETY STAND
  1. 1. WHEEL CHOCKS
  2. 2. SAFETY STAND
  1. 2.
    Hold the tyre and turn it counterclockwise continuously for more than one rotation.
Illustration · When decelerating in a forward gear (2WD mode)
  • If the rotation of the wheel does not gradually feel heavy while rotating, the 2WD system when decelerating is a forward gear is normal.
  • If the rotations of the wheel gradually feels heavy, there is a problem in the system. Check the differential fluid. If the fluid is normal, replace the torque control differential case kit.

When decelerating in reverse gear (4WD mode)

  1. 1.
    Block the front wheels, raise the left rear wheel and support it with a safety stand as shown.
Illustration: WHEEL CHOCKS; SAFETY STAND
  1. 1. WHEEL CHOCKS
  2. 2. SAFETY STAND
  1. 2.
    Hold the tyre and turn it counterclockwise continuously for more than one rotation.
Illustration · When decelerating in reverse gear (4WD mode)
  • If the rotation of the wheel does not gradually feel heavy while rotating, the 2WD system when decelerating is a forward gear is normal.
  • If the rotations of the wheel gradually feels heavy, there is a problem in the system. Check the differential fluid. If the fluid is normal, replace the torque control differential case kit.