Workshop manual

Interlock System (KQ and KU Models)

Key Interlock Solenoid Test

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 630 (manual page 14-75)

PDF p. 630 · 14-75

SRS components are located in this area. Review the SRS component locations, precautions and procedures in the SRS (section 23) before performing repairs or service.

  1. 1.
    Remove the dash board lower cover (see section 20)
  2. 2.
    Disconnect the key interlock switch connector from the steering lock assembly.
  3. 3.
    Shift the shift lever into P position.
  4. 4.
    Check for continuity between connector terminal while the key is pushed and check for no continuity when the key is released.
Illustration: KEY INTERLOCK SWITCH CONNECTOR; Wire side of female terminals
  1. 1. KEY INTERLOCK SWITCH CONNECTOR
  2. 2. Wire side of female terminals
  1. 5.
    Check that the key cannot be removed with power connected to the No. 2 terminal and ground to the No. 1 terminal.
    • If the key cannot be removed, the key interlock solenoid is OK.
    • If the key can be removed, replace the steering lock assembly (the key interlock solenoid is not available separately).

Parking Pin Switch Test

  1. 1.
    Remove the front console (see section 20)
  2. 2.
    Disconnect the parking pin switch connector
  3. 3.
    Shift the shift lever into P position, then check for continuity between the connector terminals. There should be continuity.
Illustration: PARKING PIN SWITCH CONNECTOR; Terminal side of male terminals
  1. 1. PARKING PIN SWITCH CONNECTOR
  2. 2. Terminal side of male terminals
  1. 4.
    Shift the shift lever out of the P position and check for continuity. There should be no continuity.
  2. 5.

    If the parking pin switch is faulty, replace the detent plate.

    NOTE:

    • The parking pin switch is not available separately from the detent plate; it is integrated into the detent plate.
    • If the parking pin switch replacement is required, refer to detailed shift lever disassembly (See Page 14-172).