Workshop manual

Start Clutch Control

Start Clutch Calibration Procedure

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 626 (manual page 14-71)

PDF p. 626 · 14-71

When the following the parts are replaced, the PCM must memorise the feedback signal for the start clutch control.

  • PCM
  • Transmission assembly
  • Start clutch assembly
  • Lower valve body assembly
  • Engine assembly or overhaul
  1. 1.
    Start the engine and warm up to normal operating temperature (the radiator fan comes on).
  2. 2.
    Shift to D position.
  3. 3.

    Turn all electrical system OFF.

    NOTE: Except headlights; you can calibrate with the headlights stay on.

  4. 4.
    Drive the vehicle on a flat road
  5. 5.

    Accelerate to the speed 37 mph (60 km/h), the release the accelerator and decelerate for 5 seconds.

    NOTE:

    • Do not depress the brake pedal to decelerate.
    • The start clutch feedback control signal have been memorised in the PCM.
  6. 6.
    Test-drive the vehicle and check that the engine does not stall and the vehicle can start off smoothly.
    • If the engine stalls or any shifting failure occurs at starting off, re-calibrate the start clutch feedback control signal.