PDF p. 518 · 13-44
NOTE:
- The bearing outer race and tapered roller bearing should be replaced as a set.
- Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
- 1.Remove the oil seals from the transmission housing and clutch housing (See page 13-47).
- 2.Drive the bearing outer race and thrust shim out of the transmission housing, or remove the bearing outer race and 75 mm shim from the clutch housing by heating the clutch housing to about 212°F (100°C) with a heat gun.
TRANSMISSION HOUSING:

- 1. HANDLE DRIVER, 07749-0010000
- 2. BEARING OUTER RACE
- 3. THRUST SHIM
- 4. DRIVER ATTACHMENT, 52 x 55 mm, 07746-0010400
CLUTCH HOUSING:

- 3.
Install the thrust shim or 75 mm shim and the bearing outer race in the transmission housing and clutch housing using the special tools as shown.
NOTE:
- Install the bearing outer race squarely.
- Check that there is no clearance between the bearing outer race, thrust shim or 75 mm shim and housing.
TRANSMISSION HOUSING:

- 1. HANDLE DRIVER, 07749-0010000
- 2. THRUST SHIM
- 3. BEARING OUTER RACE
- 4. DRIVER ATTACHMENT, 62 x 68 mm, 07746-0010500
CLUTCH HOUSING:

- 1. HANDLE DRIVER, 07749-0010000
- 2. DRIVER ATTACHMENT, 72 x 75 mm, 07746-0010600
- 3. 75 mm SHIM
- 4. BEARING OUTER RACE
- 4.Install the oil seal (See page 13-47).