Workshop manual

Differential

Inspection/Replacement

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 517 (manual page 13-43)

PDF p. 517 · 13-43

  1. 1.
    Place the differential assembly on V-blocks and install both axles.
  2. 2.

    Measure the backlash of both pinion gears. If the backlash is not within the standard, replace the differential carrier.

    Standard (New): 0.05 - 0.15 mm (0.002 - 0.006 in)

Illustration: DIAL INDICATOR; PINION GEARS; V-BLOCK
  1. 1. DIAL INDICATOR
  2. 2. PINION GEARS
  3. 3. V-BLOCK
  1. 3.

    Remove the tapered roller bearing using a bearing puller and a bearing separator as shown.

    NOTE: The tapered roller bearing and bearing outer race should be replaced as a set.

Illustration: BEARING PULLER; BEARING SEPARATOR (Commercially available); TAPERED ROLLER BEARING
  1. 1. BEARING PULLER
  2. 2. BEARING SEPARATOR (Commercially available)
  3. 3. TAPERED ROLLER BEARING
  1. 4.

    Remove the bolts in a crisscross pattern in several steps, remove the final driven gear and transfer driven gear from the differential carrier.

    NOTE: The final driven gear bolts have left-hand threads.

Illustration: 10 x 1.0 mm, 103 Nm (10.5 kgf/m, 75.9 lbf/ft) Left hand threads; DIFFERENTIAL CARRIER; FINAL DRIVEN GEAR Inspect for wear and damage; TRANSFER DRIVEN GEAR Inspect for wear and damage
  1. 1. 10 x 1.0 mm, 103 Nm (10.5 kgf/m, 75.9 lbf/ft) Left hand threads
  2. 2. DIFFERENTIAL CARRIER
  3. 3. FINAL DRIVEN GEAR
    Inspect for wear and damage
  4. 4. TRANSFER DRIVEN GEAR
    Inspect for wear and damage
  1. 5.
    Install the final driven gear and transfer driven gear to the differential carrier, tighten the bolts in a crisscross pattern in several steps.
  2. 6.

    Install new tapered roller bearings using the special tool as shown.

    NOTE: Drive the tapered roller bearings on until they bottom against the differential carrier.

Illustration: PRESS; ATTACHMENT, 40 x 50 mm, 07LAD-PW50601
  1. 1. PRESS
  2. 2. ATTACHMENT, 40 x 50 mm, 07LAD-PW50601
  1. 3.
    TAPERED ROLLER BEARING