Workshop manual

Synchro Sleeve, Synchro Hub

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 514 (manual page 13-40)

PDF p. 514 · 13-40

  1. 1.
    Inspect gear teeth on all synchro hubs and synchro sleeves for rounded off corners, which indicate wear.
  2. 2.

    Install each synchro hub in its mating synchro sleeve and check for freedom of movement.

    NOTE: If replacement is required, always replace the synchro sleeve and synchro hub as a set.

Illustration: SYNCHRO SLEEVE; SYNCHRO HUB
  1. 1. SYNCHRO SLEEVE
  2. 2. SYNCHRO HUB

Installation

When assembling the synchro sleeve and synchro hub, be sure to match the three sets of longer teeth (120 degrees apart) on the synchro sleeve with the three sets of deeper grooves in the synchro hub.

Illustration: SYNCHRO HUB; LONGER TEETH; SYNCHRO HUB SLOT; SYNCHRO SLEEVE
  1. 1. SYNCHRO HUB
  2. 2. LONGER TEETH
  3. 3. SYNCHRO HUB SLOT
  4. 4. SYNCHRO SLEEVE