Workshop manual

Countershaft Assembly

Clearance Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF pages 507, 508 (manual pages 13-33 to 13-34)

PDF p. 507 · 13-33

NOTE: If replacement is required, always replace the synchro sleeve and hub as a set.

  1. 1.

    Measure the clearance between the 1st gear and thrust washer.

    Standard: 0.06 - 0.18 mm (0.002 - 0.007 in)

    Service Limit: 0.23 mm (0.009 in)

Illustration: FEELER GAUGE; 1ST GEAR; THRUST WASHER
  1. 1. FEELER GAUGE
  2. 2. 1ST GEAR
  3. 3. THRUST WASHER
  1. 2.

    If the clearance is more than the service limit, measure the thickness of the thrust washer.

    Standard: 1.95 - 1.97 mm (0.077 - 0.078 in)

Illustration · Countershaft Assembly · Clearance Inspection
  1. 3.

    If the thickness is less than the standard, replace the thrust washer with a new one.

    If the thickness is within the service limit, measure the thickness of the 1st gear.

    Standard: 26.95 - 27.00 mm (1.061 - 1.063 in)

Illustration · Countershaft Assembly · Clearance Inspection
  • If the thickness of 1st gear is less than the standard, replace 1st gear with a new one.
  • If the thickness of 1st gear is within the standard, replace 1st/2nd synchro hub with a new one.

PDF p. 508 · 13-34

  1. 4.

    Measure the clearance between the 2nd gear and 3rd gear.

    Standard: 0.07 - 0.14 mm (0.003 - 0.006 in)

    Service Limit: 0.18 mm (0.007 in)

Illustration: FEELER GAUGE; 3rd GEAR; 2ND GEAR; SPACER
  1. 1. FEELER GAUGE
  2. 2. 3rd GEAR
  3. 3. 2ND GEAR
  4. 4. SPACER
  1. 5.

    If the clearance is more than the service limit, measure the thickness of the spacer.

    Standard: 29.07 - 29.09 mm (1.144 - 1.145 in)

Illustration · Countershaft Assembly · Clearance Inspection
  1. 6.

    If the thickness is less than the standard, replace the spacer with a new one.

    If the thickness is within the standard, measure the thickness of the 2nd gear.

    Standard: 28.92 - 28.97 mm (1.139 - 1.141 in)

Illustration · Countershaft Assembly · Clearance Inspection
  • If the thickness of 2nd gear is less than the standard, replace 2nd gear with a new one.
  • If the thickness of 1st gear is within the standard, replace 1st/2nd synchro hub with a new one.