Workshop manual

Countershaft Assembly

Index

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 506 (manual page 13-32)

PDF p. 506 · 13-32

OIL Prior to reassembling, clean all the parts in solvent, dry them and apply lubricant to any contact surfaces.

Illustration: REVERSE GEAR Inspection, (See page 13-40); 1ST/2ND SYNCHRO HUB Inspection, (See page 13-40); FRICTION DAMPER Check for wear and damage; SYNCHRO SPRING; DOUBLE CONE SYNCHRO Inspection, (See page 13-41); 1ST GEAR Inspection, (See page 13-33) and (See page 13-41); NEEDLE BEARING Check for wear and damage; THRUST WASHER Inspection, (See page 13-33); COUNTERSHAFT Inspection, (See page 13-36); LOCKNUT, Replace 127 to 0 to 127 Nm (13 to 0 to 13 kgf/m, 94 to 0 to 94 lbf/ft); SPRING WASHER; BALL BEARING Check for wear and operation; NEEDLE BEARING Check for wear and operation; 5TH GEAR; 4TH GEAR; 3RD GEAR; 2ND GEAR Inspection, (See page 13-34) and (See page 13-41); NEEDLE BEARING Check for wear and operation; SPACER Selection, (See page 13-34); FRICTION DAMPER Check for wear and damage; DOUBLE CONE SYNCHRO Inspection, (See page 13-41); SYNCHRO SPRING
  1. 1. REVERSE GEAR
    Inspection, (See page 13-40)
  2. 2. 1ST/2ND SYNCHRO HUB Inspection, (See page 13-40)
  3. 3. FRICTION DAMPER
    Check for wear and damage
  4. 4. SYNCHRO SPRING
  5. 5. DOUBLE CONE SYNCHRO Inspection, (See page 13-41)
  6. 6. 1ST GEAR
    Inspection, (See page 13-33) and (See page 13-41)
  7. 7. NEEDLE BEARING
    Check for wear and damage
  8. 8. THRUST WASHER
    Inspection, (See page 13-33)
  9. 9. COUNTERSHAFT
    Inspection, (See page 13-36)
  10. 10. LOCKNUT, Replace
    127 to 0 to 127 Nm (13 to 0 to 13 kgf/m, 94 to 0 to 94 lbf/ft)
  11. 11. SPRING WASHER
  12. 12. BALL BEARING
    Check for wear and operation
  13. 13. NEEDLE BEARING
    Check for wear and operation
  14. 14. 5TH GEAR
  15. 15. 4TH GEAR
  16. 16. 3RD GEAR
  17. 17. 2ND GEAR
    Inspection, (See page 13-34) and (See page 13-41)
  18. 18. NEEDLE BEARING
    Check for wear and operation
  19. 19. SPACER
    Selection, (See page 13-34)
  20. 20. FRICTION DAMPER
    Check for wear and damage
  21. 21. DOUBLE CONE SYNCHRO Inspection, (See page 13-41)
  22. 22. SYNCHRO SPRING