Workshop manual

Mainshaft Assembly

Reassembly

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 505 (manual page 13-31)

PDF p. 505 · 13-31

NOTE: For reassembly sequence (See page 13-27).

  1. 1.

    Support 2nd gear on steel blocks as shown, then install the 3rd/4th synchro hub using the special tools and a press as shown.

    NOTE: After installing, inspect the operation of the 3rd/4th synchro hub set.

Illustration: DRIVER, 40 mm I.D., 07746-0030100; PRESS; 3RD/4TH SYNCHRO HUB; 2ND GEAR
  1. 1. DRIVER, 40 mm I.D., 07746-0030100
  2. 2. PRESS
  3. 3. 3RD/4TH SYNCHRO HUB
  4. 4. 2ND GEAR
  1. 2.
    Install the 5th synchro hub using the special tools and a press as shown.
Illustration: PRESS; DRIVER, 40 mm I.D., 07746-0030100; ATTACHMENT, 35 mm I.D., 07746-0030400; 5TH SYNCHRO HUB
  1. 1. PRESS
  2. 2. DRIVER, 40 mm I.D., 07746-0030100
  3. 3. ATTACHMENT, 35 mm I.D., 07746-0030400
  4. 4. 5TH SYNCHRO HUB
  1. 3.
    Install the ball bearing using the special tools and a press as shown.
Illustration: PRESS; BALL BEARING; HANDLE DRIVER, 07749-0010000; DRIVER ATTACHMENT, 42 x 47 mm, 07746-0010300
  1. 1. PRESS
  2. 2. BALL BEARING
  3. 3. HANDLE DRIVER, 07749-0010000
  4. 4. DRIVER ATTACHMENT, 42 x 47 mm, 07746-0010300