Workshop manual

Mainshaft Assembly

Inspection

Shop Manual 1999 · source: HRV_Workshop_Manual.pdf, PDF page 504 (manual page 13-30)

PDF p. 504 · 13-30

  1. 1.

    Inspect the gear surface and bearing surface for wear and damage, then measure the mainshaft at points A, B and C.

    Standard:

    A (Ball bearing surface):27.987 - 28. 000 mm
    (1.1018 - 1.1024 in)
    B (Needle bearing surface):37.984 - 38.000 mm
    (1.4954 - 1.4961 in)
    C (Ball bearing surface):27.977 - 27. 990 mm

    (1.1015 - 1.1020 in) Service Limit:

A: 27.94 mm (1.100 in) B: 37.93 mm (1.493 in) C: 27.94 mm (1.100 in)

Illustration: Inspect for wear and damage; Inspect oil passages for clogging; Inspect for wear and damage
  1. 1. Inspect for wear and damage
  2. 2. Inspect oil passages for clogging
  3. 3. Inspect for wear and damage
  • If any part of the mainshaft is less than the service limit, replace it with a new one.
  1. 2.

    Inspect for runout.

    Standard:0.02 mm (0.0008 in) max.
    Service Limit:0.05 mm (0.002 in)

    NOTE: Support the mainshaft at both ends as shown.

Illustration: Rotate two complete revolutions
  1. 1. Rotate two complete revolutions
  • If the runout is more than the service limit, replace the mainshaft with a new one.